1/24 Scale Slotcar Chassis Jig - Duel Project Jig

Description

Thank you for looking
Made to order by father in daughter in Michigan, USA.
This new duel project Chassis Build Jig
** Similar to Lucky Bob **
THIS JIG CAN BE USED FOR SCRATCH BUILDING Drag or Road Cars.
IT IS SET UP FOR 1/8 OR 3/32 AXLE AND IS 15" LONG.
Axle alignment holes spaces every inch on both 1/8 and 3/32 side for multi platform building.
Guide flag Inlaid surface and multiple point axle alignment holes allow for cars of multiple purpose and length.
Two sets ( 8 ) total pins included.
Dimensions:
4 Inches Wide
15 Inches Long
Guide Flag Inlay: .125
Guide Flag Slot: Through Material
Material Thickness: 12mm / 1/2 inch
Pin Thickness: 1/8 ( Tap Mount )
Finished Edges: 1/8 round routed ( No Sharp Edges here ! )
True to be a toolbox favorite amongst Drag Racers and Road Racers !